Projection In Embroidery Stitch-Out - Husqvarna VIKING Designer Epic 3 User Manual

2. Move Locked Point on Fabric
The cursor will be locked to the design. It will change color
with a ring around the center of the locking point. Touch and
move with your finger on the screen to position your design
exactly where you want it to match on the fabric or to the
previously stitched design. Use the fine tuning controls to
fine tune. Watch the hoop until the needle is exactly where
you want it to be on the fabric or the previously stitched
design. The locking point on the fabric shows the position of
the needle in the design.
Note: If you also need to adjust the angle of the design, continue with
step 3.
3. Set Matching Point on Screen
Select another matching point on the design to match a
second position on the fabric or previously stitched design.
Touch and move the cursor on the screen to where you
would like the matching point to be in your design. Fine tune
with the fine tuning controls. Use zoom to cursor to
maximize the zoom and pan the embroidery area for exact
position of the cursor.
4. Rotate Design on Fabric
Rotate is automatically selected. Touch and move using your
finger on the screen, or use the fine tuning controls, to rotate
the design until the needle is exactly where you want it to be
on the fabric or the previously stitched design.

Projection in Embroidery Stitch-Out

You can use the projector as a help when positioning a
design on the fabric. Maybe you want to cover a stain, place
another design in relation to an already embroidered one, or
put your design on, for instance, a pocket.
When the projection is activated, the projector will show an
image of the embroidery design(s) to be projected onto your
hooped fabric. The cross hair shown on the screen
corresponds to the machines needle position.
The projector has a projection area of approximately 4" x
2.4"(10x6cm) in front of the needle. If the embroidery design
is larger than the projection area, the part of the design(s)
that fits inside the projection area is shown on the fabric.
You can move the position of the projection area by using
the move hoop. By touching the positioning arrows, the
cross hair on the screen and the hoop moves simultaneously
to your desired position. The embroidery projection updates
as you edit the position, orientation, color, etc. of the selected
embroidery design.
Note: The embroidery arm and hoop will move when using the move
hoop control, make sure the area around the embroidery unit is cleared.
10 Embroidery Stitch-Out 127