Toshiba TOSVERT VF-P7 Instruction Manual page 60

■Searching for a parameter and changing its setting
Follow the procedure below to search for parameters and change their settings.
Key operated
MON
▲ ▼
ENT
ENT
OR
▲ ▼
ENT
▲ ▼
ENT
▲
▼
( )
▲
▼
( )
MON
MON
If you feel puzzled about what to do next during this operation, press the Monitor key
several times to return to the step  and follow the above steps all over again.
LED display
The operation frequency is displayed. (Make this setting
when the motor is out of operation.)(If the monitor display

mode setting parameter
frequency])
Press the MON key to call up the first basic parameter

 (Automatic acceleration/deceleration).
Select the user group parameter  by pressing the

△ or ▽ key.
Press the Enter key to enter the user parameter search

and change mode.
The inverter searches for and displays parameters the
settings of which are different from their respective
default settings. Press the Enter key or△ key to switch

parameters displayed. (Press the▽key to search for
parameters in reverse direction.)
Press the [MON] key to display the parameter setting

(set value).
Change the parameter setting by pressing △ or ▽

key.
Press the enter key to save the change. Then, the
parameter code and the set value are displayed

alternately.
Following the same steps as above, search for and
display other parameters you want to change, one by

() one, by pressing the △ or ▽ key, to check or change
their settings.
 is displayed again after completion of a

search for all changed parameters.
Parameter display
To cancel the parameter search in process, press the
↓
Monitor key. Press the Monitor key once during search
to return to parameter setting mode. Then, press the

Monitor key to return to status monitor mode or normal
↓
monitor mode (operation frequency display mode).

D-6
Operation
is set at [Running
