Toshiba TOSVERT VF-P7 Instruction Manual page 56

★About the parameter's adjustment range
: A value larger than the upper-limit value is entered or the value set for the currently-selected
parameter becomes larger than the upper-limit value because another parameter was changed.
: A value smaller than the lower-limit value is entered or the value set for the currently-selected
parameter becomes smaller than the lower-limit value because another parameter was changed.
If the above alarm code  or  blinks, change the parameter setting below the  value or
above the  value, respectively. When any of these alarm codes is blinking, no change can be
made to any parameter.
4.1.1 How to set basic parameters [Basic parameter]
Every basic parameters can be set in the same way.
[Procedure for setting a basic parameter]
MON
▲ ▼
ENT
▲ ▼
ENT
Follow the procedure below to set a basic parameter.
(Example of setting: Changing the maximum frequency from 80 to 60 Hz)
Key operated
MON
▲ ▼
ENT
▲ ▼
ENT
After this,
：
Press this key to switch to setting
monitor mode.
：
Press these keys to select the
parameter you want to change.
：
Press this key to display the
parameter setting.
：
Press these key to change the
parameter setting.
：
Press this key to save the change.
LED display






→ Press this key to
ENT
display the same
parameter setting
The operation frequency is displayed. (Out of operation.)
(If the monitor display mode setting parameter
set at [Operation frequency])
Press the [MON] key to call up the first basic parameter
 (automatic acceleration/deceleration).
Select "" by pressing the △ or ▽ key.
Press the Enter key to display the changed maximum
frequency.
Change the maximum frequency to 60 Hz by pressing▽
key.
Press the Enter key to save the change. Then,  and the
set maximum frequency are displayed alternately.
→ Press this key to
MON
switch to status
.
monitor mode.
D-2
★ The inverter is shipped with
certain parameters factory-set
by default.
★ Use "Parameter list" to select the
parameters you want to change.
★ If you feel puzzled about what to
do next during this operation,
press the Monitor key to return to
the first step ( is displayed).

Operation
→ Press these keys
▲ ▼
to call up other
parameters.
is
