Toshiba TOSVERT VF-P7 Instruction Manual page 136

voltage signals
current signals
6.22 Torque limit
 ：Selection of power running torque limit #1
 ：Power running torque limit #1
 ：Selection of regenerative torque limit #1
 ：Regenerative torque limit #1
 ：Power running torque limit #2
 ：Regenerative torque limit #2
 ：Power running torque limit #3
 ：Regenerative torque limit #3
 ：Power running torque limit #4
 ：Regenerative torque limit #4
 ：Torque limit mode (polarity)
・ Function
The function is to decrease or increase the output frequency according to the load
ing condition when the motor torque reaches the limit level.
Setting a torque limit parameter at 250.0 means "Invalid".
■Setting
(1) Power running /regenerative torque limit
First, you need to set the polarity of each torque limit. Set  at .
Title

a）limiting the torque with internal parameters (or on communication mode)
Reverse
Torque limits can be set with the parameters  and .
[Setting of power running torque]
(Selection of power running torque limit #1) :Set at (  )
(Power running torque limit #1)
[Setting of regenerative torque]
(Selection of regenerative torque limit #1)
(Regenerative torque limit #1)
RR-CC ―― 0∼10V
RX-CC ―― 0∼±10V
VI-CC
II-CC
Function
Torque limit
mode (polarity)

Regenerative
Power running

(0∼250%)
(0∼250%)
―― 0∼10V (0∼250%)
―― 4(0)∼20mA (0∼250%)
Adjustment range
: Power running/regenerative torque limit
: Positive/negative torque limit

Power running
Regenerative

:Set a desirable torque limit level.
:Set at (  )
:Set a desirable torque limit level.
F-44
, 




Setting value

＋250% torque
Forward
−
250% torque