Removing The Right Control Panel; Installing The Right Control Panel - Dell PowerEdge HS5620 Installation And Service Manual

Removing the right control panel

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the drive backplane
4. Remove the air shroud.
Steps
1. Disconnect the control panel cable and the VGA cable from the system board connector and remove the cable from cable
clip.
NOTE: Observe the routing of the cable as you remove it from the system.
2. Using the Phillips #1 screwdriver, remove the screws that secure the right control panel assembly.
3. Hold the right control panel assembly and remove the control panel along with the cable from the system.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 132. Removing the right control panel
Next steps
Replace the right control

Installing the right control panel

Prerequisites
1. Follow the safety guidelines listed in the
Safety
Before working inside your
cover.
panel.
Safety
instructions.
system.
instructions.
Installing and removing system components 165