Table of Contents
Advertisement
5. Tilt the metal bracket and tighten the captive screw.
Next steps
1.
Install the air
shroud.
2. Follow the procedure listed in
Optional BOSS-N1 module
Removing the BOSS-N1 module
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure that is listed in
3.
Remove the air
shroud.
4. If installed,
remove the front
Steps
1. Disconnect the cables connected to the system board from the BOSS-N1 module.
2. Using a Phillips 2 screwdriver, remove the screw securing the BOSS-N1 module to the system.
3. Slide the BOSS-N1 module out of the system.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 66. Removing the BOSS-N1 module
4. Align the blank with the BOSS-N1 module slot and push it into the bay until it clicks into place.
NOTE:
Blanks must be installed in empty slots to maintain FCC certification of the system. The blanks also keep dust
and dirt out of the system and aid in proper cooling and airflow inside the system.
After working inside your
Safety
instructions.
Before working inside your system
bezel.
system.
.
Installing and removing system components
101
Advertisement
Table of Contents
