Table of Contents
Advertisement
Figure 54. Installing the riser
Next steps
1.
Install the air
shroud.
2. Follow the procedure listed in
Optional BOSS-N1 module
Removing the BOSS N1 module
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure listed in
3.
Remove air
shroud.
Steps
1. Disconnect the cables from the BOSS N1 module.
2. Lift the retention latch to unlock the BOSS N1 M.2 module.
3. Pull the BOSS N1 M.2 module out from the rear of the system.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
86
Installing and removing system components
After working inside your
Safety
instructions.
Before working on your
system.
system.
Advertisement
Table of Contents
