Advertisement
(c)
Remove the Diagnostics Disk from the FDD, insert the source disk, and
press any key. The following message will appear, indicating the program
has started.
[ FDD TYPE ] : TRACK
[ FDD TYPE ] : HEAD
[ FDD TYPE ] : SECTOR = XX
Copy start
(d)
Remove the source disk from the FDD, insert a formatted work disk, and
press any key. The [[ track, head = XXX X ]] message will appear and
start copying to the target disk. When the amount of data is too large to be
copied in one operation, the message from step (b) is displayed again. After
the floppy disk has been copied, the following message will appear:
Copy complete
Another copy (1:Yes/2:No) ?
(e)
To copy another disk, type 1 and the message from step (a) will be displayed
again. Entering 2 returns the test program to the DIAGNOSTIC MENU.
4.
DUMP program
(a)
When dump is selected, the following message appears:
DIAGNOSTICS-HARD
Drive type select (1:FDD, 2:HDD) ?
(b)
Select a format type number. If 2 is selected, the display will go to step (e).
Select FDD number (1:A, 2:B) ?
(c)
Select a drive number and the following message will be displayed:
Format type select (0:2DD, 1:2D, 2:2HD) ?
(d)
Select a media type number and the following message will appear:
Insert source disk into drive A:
Press any key when ready.
(e)
Insert a source disk and press any key and the following message will appear:
—— Max. address ——
(f)
Set the track number you want to dump. The system will access the disk and
dump a list.
610CT
= XXX
= X
[[ track,head
DISK & FLOPPY DISK DUMP : VX.XX
[Track ] = 0079
[ Head ] = 01
[Sector] = 09
Track
number ??
=
XXX X ]]
3-49
Advertisement
