Advertisement
Procedure 2
Message Check
When the 610CT HDD does not function properly, some of the following error messages may
appear on the display. Start with Check 1 below and perform the other checks as instructed.
Check 1
If any of the following messages appear, perform Check 2. If the following mes-
sages do not appear, perform Check 4:
HDC ERROR
(After 5 seconds this message will disappear)
HDD #0 ERROR
(After 5 seconds this message will disappear)
HDD #1 ERROR
(After 5 seconds this message will disappear)
Check 2
If either of the following messages appears, perform Procedure 3. If the following
messages do not appear, perform Check 3.
Insert system disk in drive
Press any key when ready .....
Non-System disk or disk error
Replace and press any key
Check 3
Using the Toshiba MS-DOS system disk, install a system program on the hard disk
using the SYS command.
If the following message appears on the display, the system program has been
transferred to the HDD. Restart the 610CT. If the error message still appears,
perform Check 4.
System transferred
Check 4
The HDD is connected to the system board. This connection can become dam-
aged or disconnected. Disassemble the 610CT as described in chapter 4, Replace-
ment Procedures. If the HDD is not connected to the flexible cable, connect it to
the flexible cable and return to Procedure 1. If the flexible cable is not connected
to the system board, connect it to the system board and return to Procedure 1. If
the HDD and flexible cable are firmly connected to the system board, perform
Procedure 3.
System Board
2-20
or
or
or
HDD
610CT
Advertisement
