Advertisement
Installing the LED Board and speaker
To install the 610CT LED board and speaker, follow the steps below and refer to figure 4-24.
1.
Put the protective rubber cover on the speaker.
2.
Place the speaker in the assembly and secure the two latches.
3.
Place the LED board in the assembly and secure the four latches.
4.
Seat the assembly in the bottom cover.
5.
Secure the LED board and speaker assembly with two M2.5x4 screws.
6.
Replace the top cover, HDD, keyboard, optional PCMCIA card, optional memory
card, and battery pack as described in sections 4.7 back through 4.2.
610CT
4-35
Advertisement
