Advertisement
Installing the Keyboard
To install the 610CT keyboard, follow the steps below and refer to figures 4-9 through 4-12.
1.
Connect the AccuPoint cable to PJ2 and keyboard cable to PJ7 (figure 4-12).
2.
Replace the keyboard. Fit tongues on the back of the keyboard into corresponding
holes on the top cover and lay the keyboard in place.
3.
Secure one M2x4 screw with washer in front of the keyboard (figure 4-10).
4.
Seat the keyboard cover and press firmly to secure the twelve latches (figure
4-9).
5.
Replace the optional PCMCIA card, optional memory module, and battery pack as
described in sections 4.4, 4.3, and 4.2.
610CT
4-15
Advertisement
