Advertisement
3.2
Executing the Diagnostic Test
Toshiba MS-DOS is required to run the 610CT Diagnostic Test Program. To start the Diag-
nostic Test Program follow these steps:
1.
Insert the 610CT Diagnostics disk in the computer's external floppy disk drive and
turn the computer on.
2.
At the system prompt, change to drive A and type the test command, and press
Enter.
The following menu will appear:
TOSHIBA personal computer PT610CT DIAGNOSTICS
version X.XX (c) copyright TOSHIBA Corp. 19XX
DIAGNOSTICS MENU :
1 - DIAGNOSTIC TEST
2 - HARD DISK FORMAT
3 -
4 - HEAD CLEANING
5 - LOG UTILITIES
6 - RUNNING TEST
7 - FDD UTILITIES
8 - SYSTEM CONFIGURATION
9 - EXIT TO MS-DOS
0 - SETUP
NOTE: To exit the menu, press the Esc key. If a test program is in progress, press
Ctrl + Break to exit the test program or press Ctrl + C to stop the test program.
3-2
↑↓→←
:
Select items
Enter
:
Specify
Esc
:
Exit
610CT
Advertisement
