Advertisement
Installing the Top Cover
To install the 610CT top cover, follow the steps below and refer to figures 4-15 to 4-17.
1.
Set the top cover in place and snap in the nine latches (figures 4-16 and 4-17).
2.
Rethread the microphone cable.
3.
Connect the following cables: LED to PJ9, FL inverter to PJ13, display to PJ12,
speaker to PJ18, display panel open sensor to PJ17, and microphone to PJ2.
4.
Replace the tape to secure the cables.
5.
Close the display and turn the computer upside down.
6.
Secure the top cover with eight M2x8 silver screws and two M2x6 silver screws.
7.
Replace the HDD, keyboard, optional PCMCIA card, optional memory card, and
battery pack as described in sections 4.6, 4.5, 4.4, 4.3, and 4.2.
610CT
4-21
Advertisement
