Advertisement
Installing an Optional Memory Module
To install an optional memory module in the 610CT, follow the steps below and refer to
figures 4-4 through 4-6.
1.
Position the connector on the bottom of the module over the corresponding
connector on the computer (align the holes on the side of the module over the
screw holes on the brace). Place your fingers above the connector and press firmly
but gently to assure a solid connection. The module should be seated level (figure
4-6).
2.
Secure the module to the brace with two screws (figure 4-5).
3.
Fold down the plastic tab and lay the cover in place. Secure it with two screws
(figure 4-4).
4.
Replace the battery pack as described in section 4.2.
5.
When you turn the computer on, it should automatically recognize the total
memory capacity. Verify that the added memory is recognized.
4-10
Figure 4-6 Inserting the memory module
610CT
Advertisement
