Connector And Pin-Out Reference; More Information - Nortel Remote Gateway 9150 Installation And Administration Manual

Nortel remote gateway 9150: user guide

Hide thumbs Also See for Remote Gateway 9150:

Table of Contents

Installing the Remote Gateway 9150 unit

— The analog device must be located no farther than 307.7 meters

(1000 feet) from the Remote Gateway 9150 unit.

Ethernet cable

If you are connecting the Remote Gateway 9150 unit to a hub, you need a

standard CAT5 un-shielded twisted-pair (UTP) straight-through Ethernet

cable. The cable must be no longer than 100 meters (325 feet) in length.

Connector and pin-out reference

The following table identifies where to find the pin-out table for each connector:

The following documents describe how to establish telephone and trunk

connections using the Meridian 1 PBX BIX in-building cross-connect system:

Meridian 1 PBX Installation planning (NTP 553-3001-120)

Telephone and attendant console installation (NTP 553-3001-215)

BIX* In-Building Cross-Connect System Material Installation and

Servicing (Wall-Mounted System) (NTP 631-4511-200)

Connection type

25 TIP and RING pairs

Remote Gateway 9150 Installation and Administration Guide

For the pin-out table, refer to

Standard 4.0