Nortel Remote Gateway 9150 Installation And Administration Manual page 300

Nortel remote gateway 9150: user guide

Hide thumbs Also See for Remote Gateway 9150:

Table of Contents

Using Remote Gateway 9150 stations

Release and Try

Bandwidth Limit

Call Failure

All Remote Gateway 9150 trunks are busy or there

are not enough DSP resources to process the call.

Try again at a later time.

Note: Ensure the call you are placing is initiated

from the appropriate call appearance key:

host call appearance key: to call someone at the

host PBX site

local call appearance key: to place a local PSTN

call or to call another station at your site

If this message displays on your station and you hear

a fast busy signal when you attempt to place a call,

then there is insufficient PSTN bandwidth.

Wait a moment, and then try your call again.

If you see this message and hear a fast busy signal

when you attempt to place a call, then Digital Signal

Processor (DSP) resources are all busy.

Wait a moment, and then try your call again.

If you see this message and hear a fast busy signal

when you attempt to place a call, then the Remote

Gateway 9150 unit failed to establish the PSTN

connection to the RLC.

Wait a moment, and then try your call again.

Remote Gateway 9150 Installation and Administration Guide

Standard 4.0