Nortel Remote Gateway 9150 Installation And Administration Manual page 152

Installing the Remote Gateway 9150 unit
The following is a completed example:
Click on the Yes
option button to
allow voice calls
over IP, then enter
the RLC's IP
address.
Click on the Yes
option button to
allow voice calls
over the PSTN,
then enter the
RLC's phone
number.
Click on the Yes
option button to automatically assign Remote Gateway 9150 unit ports to RLC
ports, then enter the information as described previously.
8 Click on the Next button.
Result: The Enter the BRI module data dialog box displays. A completed
example is shown on page 125.
9 Complete the fields on this dialog box as described in the following table:
Field
Which module would you
wish to configure
Module Status
124
Description
Click on the option button immediately to the
left of the number of the trunk interface
module that you are configuring.
The number you select must match the
position where the module has been installed
in the Remote Gateway 9150 unit.
This field identifies whether a module has
been physically installed on the Remote
Gateway 9150 unit.
Remote Gateway 9150 Installation and Administration Guide
Standard 4.0