Nortel Remote Gateway 9150 Installation And Administration Manual page 88

Planning for Remote Gateway 9150 unit installation
Note: When the administration PC is connected to the Remote Gateway 9150
unit through the serial port, you can view the command line interface using an
application such as Telnet or HyperTerminal. However, the command line
interface is not documented in this guide. Configuration Manager is the
supported tool for administering the Remote Gateway 9150 unit over the serial
port.
Ethernet connection
Once you configure the Remote Gateway 9150 unit with its IP interface
information, the following can happen:
Communication can be established between the Remote Gateway 9150 unit
and the RLC (that is, calls can be routed over the IP network).
You can administer and upgrade the Remote Gateway 9150 unit over the IP
network.
This means you do not have to install an administration PC in the same
location as the Remote Gateway 9150 unit. Refer to the following
illustration:
Remote Gateway 9150
60
POW
ER
ETH
ERN
ET
TX RX
COLL
1
L1 MOD 10.1.1.2
L2 2 ULE
L1
L2
3
L1
L2
4
L1 V.35
L2
TX STA
RX TUS
Remote Gateway 9150 Installation and Administration Guide
Ethernet
network
Router
10.1.1.10
Administration
PC
10.1.1.3
Standard 4.0
Network
10.4.1.1
G101415