Nortel Remote Gateway 9150 Installation And Administration Manual page 230

Configuring the Remote Gateway 9150 unit
IF you selected
Provision ID,
3 Click on the OK button
Result: Configuration Manager writes the changes to a temporary file on
the administration PC.
4 Click on the Send button to update the Remote Gateway 9150 unit with the
new information.
Note: To save changes to the Remote Gateway 9150 unit's Flash memory,
select Upload
202
THEN
the Security ID fields are enabled.
Do the following:
Enter the RLC's security identifier (must
be a 10 digit password) in the Inbound
Security ID field.
Enter the Remote Gateway 9150 unit's
security identifier (must be a 10 digit
password) in the Outbound Security ID
field.
Note: You must configure the same
security identifiers in reverse on the RLC
port associated with this Remote
Gateway 9150 unit.
→
Save to Flash from the Menu Bar.
Remote Gateway 9150 Installation and Administration Guide
Standard 4.0