Adjusting The Interior Lighting; Changing Bulbs - Mercedes-Benz V-Class 2021 Owner's Manual

Adjusting the interior lighting

Adjusting the interior lighting
Front overhead control panel
Interior lighting buttons (example: comfort over‐
head control panel)
1p Front-left reading lamp
2| Automatic interior lighting control
3c Front interior lighting
4w Rear or load compartment lighting
5p Front-right reading lamp
To switch on/off: press the corresponding
#
button 1 – 5.
The layout and number of buttons depend on the
equipment.
Operating unit in the grab handle
1p Rear reading lamp
To switch on/off: press button 1.
#
Adjusting ambient lighting
Multimedia system:
© Comfort
4 5
Setting the colour
Select Colour.
#
Set the required colour.
#
or
Select a colour combination.
#
Ambient lighting
5
Adjusting the brightness
Select Brightness.
#
Adjust the brightness.
#
Switching the interior lighting switch-off
delay time on/off
Multimedia system:
© Settings
4 5
Int. light. del. sw. off
5
Switch the switch-off delay time on or off.
#
When this function is active, the interior light‐
ing switches on automatically when the
engine is unlocked or switched off.

Changing bulbs

Instructions for replacing light sources
& WARNING Risk of burns from hot com‐
ponent parts whilst replacing a bulb
Bulbs, lamps and plug connectors can
become very hot during operation.
When replacing a bulb, you could burn your‐
self on these component parts.
Allow the component parts to cool
#
down before replacing the bulbs.
Important safety notes
Before changing the bulbs, switch off the
R
vehicle's lighting system. This will prevent a
short circuit.
Use only spare bulbs of the same type and
R
with the correct voltage.
Use bulbs only in enclosed lamps that have
R
been designed for them.
Do not use any light source that has been
R
dropped or has scratches on its glass tube.
Otherwise, the light source may explode.
The light source may explode under the fol‐
R
lowing conditions:
if it is hot and you touch it
-
if you drop it
-
if you scratch it
-
Stains on the glass tube will reduce the
R
service life of the light source. Do not touch
the glass tube with your bare hands. If neces‐
sary, clean the glass tube with alcohol or spi‐
Light and vision 113
Lights
5