Mercedes-Benz V-Class 2021 Owner's Manual page 95

92 Seats and stowage
The berth can accommodate two persons.
Fold up the short section of bed extension
#
6.
Move the seat/bunk combination forwards to
#
mark 7 on the guide rail.
Remove the head restraints of the seat/bunk
#
combination.
Rotate the head restraints by 180° and insert
#
them into brackets
seat backrest.
Pull backrest release handle
#
the seat backrest to a horizontal position.
When doing so, hold on to the seat backrest
only by the grab strap.
Fold down the short section of the bed exten‐
#
sion 6.
Folding away the berth
Perform the steps to set up the berth in
#
reverse order.
5 on the rear side of the
8 up and adjust
After use, finish by moving the seat/bunk combi‐
nation back to the basic setting and ensure that
the seat backrest is in an upright position.
Moving the seat sliders
When you remove the seat/bunk combination, a
rear bench seat or a seat, the seat slider may
slide in a guide rail. The seat sliders will then no
longer be parallel in the guide rails. In this case,
you will no longer be able to fit the respective
seating. The seat sliders must be moved using
only the handle for seat sliders
fied specialist workshop in order to prevent the
risk of damage.
In addition, you can use the end of the handle to
open and close the locks on the sliders.
%
Handle 1 is in the stowage compartment of
the seat/bunk combination (
Place the tip of handle
#
bolt of three bolts 4.
Swing handle 1 downwards onto seat slider
#
2.
Press seat slider 2
#
handle 1.
Seat slider 2 will be unlocked.
Move seat slider 2
#
and engage it.
1 or at a quali‐
page 99).
/
1 onto the middle
into guide rail 3 with
into the correct position