Mercedes-Benz V-Class 2021 Owner's Manual page 124

Switch on the power supply or the ignition.
#
Briefly press button 1.
#
You will no longer be able to fold in the outside
mirrors once you reach a speed greater than
47 km/h.
Engaging the outside mirrors
If an outside mirror has been forcibly disengaged
forwards or backwards, proceed as follows.
Press and hold button
#
click followed by the mirror audibly engaging
in position.
The mirror housing will now be engaged and
you will be able to adjust the outside mirrors
as normal.
Resetting the outside mirrors
%
If the battery has been disconnected or com‐
pletely discharged, the outside mirrors must
be reset. Only then will the automatic mirror
folding function work properly.
Switch on the power supply or the ignition.
#
Briefly press button 1.
#
Heating the outside mirrors
Vehicles without a rear window heater: at
temperatures below 15°C, the mirror heater will
automatically switch on permanently once the
engine has been started.
Vehicles with a rear window heater: at temper‐
atures below 15°C, the mirror heater will auto‐
matically switch on for ten minutes once the
engine has been started. The mirror heater can
also be switched on together with the rear win‐
dow heater.
Switch on the ignition.
#
Press the top or bottom section of the ¤
#
rocker switch on the control panel for the air
conditioning system.
The indicator lamp above the ¤ rocker
switch will light up and the mirror heater will
be switched on together with the rear window
heater.
Using the digital rearview mirror
The vehicle may be equipped with a digital rear‐
view mirror that uses a camera in the rear win‐
dow and a display integrated in the mirror to pro‐
vide a better view to the rear. The rearview mirror
can be used either as a standard rearview mirror
or as a display.
1 until you hear a
To prevent glare from the digital rearview mirror,
first set the digital rearview mirror as the stand‐
ard rearview mirror.
%
If the camera in the rear window is dirty,
operate the rear window wiper with washer
fluid ( page 118) or clean the rear window
/
manually. Observe the notes on cleaning the
digital rearview mirror (
To use the standard rearview mirror: move
#
the switch to position 1.
To use the display: move the switch to posi‐
#
tion 2.
Adjusting the display brightness
%
The digital rearview mirror is equipped with
light sensors on the front and back and auto‐
matically adjusts the brightness of the dis‐
play to the lighting conditions. Do not cover
the light sensors, e.g. with a sticker.
Press menu button
#
Press button 4 to reduce the display bright‐
#
ness.
or
Press button 5 to increase the display
#
brightness.
Adjusting the angle of the camera
Press menu button
#
Press button 4 to move the angle down‐
#
wards.
or
Press button 5 to move the angle upwards.
#
Error mode of the digital rearview mirror
If a system error occurs, e.g. if the camera fails, a
crossed-out camera will appear at the top left of
the display and no camera image will be visible in
the mirror.
Switch to the standard rearview mirror if
#
there is a system error.
Light and vision 121
page 239).
/
3 once.
3 twice.