116 Light and vision
Please note that you can change the bulb of the
reversing light only in the case of an LED tail
lamp.
Open the tailgate.
#
%
You will find a screwdriver in the vehicle tool
kit (
page 256).
/
Unscrew two side screws 1.
#
Push tail lamp
2
outwards against bolts
#
as far as it will go.
Press tail lamp
2
#
from bolts 3.
Pull the connector off the bulb mount of tail
#
lamp 2.
Installing the tail lamp
Push the connector into the bulb mount of tail
#
lamp 2.
Push tail lamp
2
onto bolts
#
and press it against the vehicle.
Tighten two side screws 1.
#
Standard tail lamp
Unscrew three screws
#
mount
2
from the tail lamp.
off outwards and away
3
from the side
1
and remove bulb
Bulb mount
3
Turn signal light
4
Brake light, tail light, parking light
5
Reversing light
6
Rear fog light (only on the driver's side)
Remove the tail lamp.
#
Gently turn the bulb anti-clockwise and take it
#
out of the socket.
Push the new bulb into the socket and turn it
#
clockwise to screw it in.
Insert bulb mount
#
tighten all three screws 1.
3
Install the tail lamp.
#
LED tail lamp
Remove the tail lamp.
#
Unscrew housing cover
#
clockwise.
Turn the socket anti-clockwise and pull it out.
#
Pull the bulb out of the socket.
#
Insert the new bulb into the socket.
#
Insert the socket and rotate it clockwise to
#
tighten it.
Press on housing cover
#
clockwise to tighten it.
Install the tail lamp.
#
2
into the tail lamp and
1
by turning it anti-
1
and rotate it