Adjusting The Interior Lighting - Mercedes-Benz Sprinter 907 2018 Operating Instructions Manual

Table of Contents

Advertisement

Always observe the traffic carefully and
#
switch off the main beam in good time.
Adaptive Highbeam Assist automatically switches
between:
Dipped beam
R
High beam
R
The system detects that vehicle lights are
approaching in the opposite direction or driving
ahead of the vehicle.
At speeds greater than 30 km/h:
If no other road users are detected, the high
R
beam switches on automatically.
At speeds below 25 km/h or if there is sufficient
road lighting:
The high beam automatically switches off.
R
System limitations
Adaptive Highbeam Assist cannot take the road,
weather or traffic conditions into consideration.
Detection may be restricted:
in poor visibility, e.g. fog, heavy rain or snow
R
if there is dirt on the sensors or the sensors
R
are obscured.
Adaptive Highbeam Assist is only an aid. You are
responsible for ensuring correct vehicle lighting
in accordance with the prevailing light, visibility
and traffic conditions.
The system's optical sensor is located behind the
windscreen near the overhead control panel.
Switching Highbeam Assist on or off
To switch on: turn the light switch to position
#
Ã.
Switch the highbeam on using the combina‐
#
tion switch.
If the highbeam is automatically switched on
in darkness, the indicator lamp _ on the
multifunction display lights up.
To switch off: switch off the highbeam using
#
the combination switch.
Setting exterior lighting delay time
Requirements:
The light switch is in position Ã.
R
Multimedia system:
©
Settings
,
.
light shut-off
Setting a lighting delay time.
#
When the vehicle engine is switched off, the exte‐
rior lighting will be activated for the set time.
Switching surround lighting on/off
Multimedia system:
©
Settings
,
.
round lighting
Switching a function on or off.
#
The exterior lighting shines for a period of 40 sec‐
onds after unlocking. When you start the vehicle,
the surround lighting will be deactivated and the
automatic dipped beam activated.

Adjusting the interior lighting

Front overhead control panel
Variant 1
1
p Switches front left reading lamp on
#
or off
2
| Switches automatic interior lighting
#
control on or off
3
c Switches front interior lighting on or
#
off
4
w Switches rear/load compartment
#
lighting on or off
5p Switches front right reading lamp on
#
or off
85
Light and vision
Lights
Exterior
.
.
Lights
Sur-
.
.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents