Mercedes-Benz V-Class 2021 Owner's Manual page 198

You have the following options on the
menu:
Changing the settings for the driver assis‐
R
tance systems on the Assistance submenu
Changing the settings for the exterior lighting
R
on the Lights submenu
Changing the display options on the Instru‐
R
ment cluster submenu
Setting the permanent limiter on the Vehicle
R
submenu
Resetting the settings to factory settings
R
Select the desired submenu and confirm your
#
selection.
Assistance submenu
Select a driving or driver assistance system
#
and configure a setting.
®
R Switching ESP
( page 158, 157).
/
Switching Traffic Sign Assist on/off
R
( page 178).
/
Switching Active Brake Assist on/off
R
( page 160).
/
Switching Blind Spot Assist on/off
R
( page 179).
/
Adjusting ATTENTION ASSIST
R
( page 177).
/
Adjusting Lane Keeping Assist
R
( page 181).
/
Lights submenu
The following settings are possible on the Lights
submenu:
Switching the Intelligent Light System on/off
R
( page 110)
/
Switching between low beam for right- and
R
left-side traffic (in vehicles with Intelligent
Light System only)
Use the : or 9 button to select the
#
Lights submenu.
Press the a button to confirm.
#
To switch between low beam for right-
#
and left-side traffic: use the : or 9
button to select Dipped beams Setting
The display will show the selected setting.
Settings
on/off
for.
Instrument cluster and on-board computer 195
Change the selected setting with the a
#
button.
When you change the setting, the switchover
will not take place until the next time the
vehicle is stationary.
When you switch over the low beam for right- or
left-side traffic, motorway mode and the
enhanced fog light function may not be available.
This deactivation will take place only if the setting
for driving on the right or left is the opposite to
your vehicle's national version.
You can have the low beam set for right- or left-
side traffic at a qualified specialist workshop as
well.
Instrument cluster submenu
Use the : or 9 button to select the
#
Instrument cluster
Press the a button to confirm.
#
To select the unit of measurement for dis‐
#
tance: use the : or 9 button to select
the Display unit Speed-/odometer
The display will show the selected setting
or Miles.
Change the selected setting with the a
#
button.
To switch the additional speedometer on/
#
off: use the : or 9 button to select
Addit. speedo.
The current selection will appear.
Press the a button to change the setting.
#
Vehicle submenu
Use the : or 9 button to select the
#
Vehicle submenu.
Press the a button to confirm.
#
To set the permanent limiter: use the :
#
or 9 button to select
tyres).
The display will show the current setting.
To change the setting: press the a but‐
#
ton.
To save the entry: press the a button.
#
%
You can find further information in "Perma‐
nent limiter" (
/
To reset to factory settings: use the :
#
or 9 button to select the
submenu.
submenu.
function.
Limit speed (winter
page 162).
Factory settings
km