Mercedes-Benz V-Class 2021 Owner's Manual page 111

108 Light and vision
& WARNING Risk of accident when the
dipped beam is switched off in poor visi‐
bility
When the light switch is set to Ã, the
dipped beam may not be switched on auto‐
matically if there is fog, snow or other causes
of poor visibility such as spray.
In such cases, turn the light switch to
#
L.
The automatic driving lights are only an aid.
Responsibility for vehicle lighting rests with you.
If the standing lights and low beam have been
switched on, the green T (standing lights) and
L (low beam) indicator lamps on the instru‐
ment cluster will light up.
Activating/deactivating the fog light
Requirements:
The light switch is in the L or à posi‐
R
tion.
The power supply has been switched on.
R
To switch the rear fog light on or off: press
#
the button R.
Comply with the country-specific regulations for
using the rear fog lamp.
Adjusting headlamp range
Turn headlamp range adjuster
#
required position.
If the vehicle is unladen, select position g.
#
The illumination of the road should be 40 m to
100 m and low beam must not dazzle oncoming
traffic.
You can use the headlamp range adjuster to
adjust the light cone of the headlamps to your
vehicle's load condition. The light cone will
change as the seats are occupied or the load
compartment is loaded or unloaded. This can
cause visibility conditions to deteriorate and you
could dazzle oncoming traffic.
Operating the combination light switch
1
2
3
4
#
Switching on high beam
#
#
%
#
1 to the
Headlamp flashing
#
Turn signal light
#
High beam
Right turn signal light
Headlamp flashing
Left turn signal light
Use the combination switch to activate the
desired function.
Switch on the low beam (
Push the combination switch forwards 1.
The K indicator lamp on the instrument
cluster will light up.
The high beam switches to the à position
only in darkness and when the engine is run‐
ning.
To switch off: move the combination switch
back to its starting position.
The K indicator lamp goes out in the
instrument cluster.
Briefly pull the combination switch in the
direction of arrow 3.
To indicate: push the combination switch in
the required direction
page 107).
/
2 or 4 until it