Ipv6 Source Guard Policy - ZyXEL Communications XGS2220 Series User Manual

Figure 374
The following table describes the labels in this screen.
Table 294 SECURITY > IPv6 Source Guard > IPv6 Static Binding > IPv6 Static Binding > Add/Edit
LABEL
Source Address
MAC Address
VLAN
Port
Apply
Clear
Cancel

75.10 IPv6 Source Guard Policy

Use this screen to have IPv6 source guard forward valid IPv6 addresses and/or IPv6 prefixes that are
stored in the binding table and allow or block data traffic from all link-local addresses. To open this
screen, click SECURITY > IPv6 Source Guard > IPv6 Source Guard > IPv6 Source Guard Policy.
• If you select Validate Address and not Validate Prefix, traffic for a binding entry that matches a IPv6
address and VLAN ID, port number, and MAC address will be forwarded. If this binding entry is a IPv6
prefix, the traffic will be denied.
• If you select Validate Prefix and not Validate Address, traffic for a binding entry that matches a IPv6
prefix and VLAN ID, port number, and MAC address will be forwarded. If this binding entry is a IPv6
address, the traffic will be denied.
• If you select both Validate Prefix and Validate Address then traffic matching either IPv6 address or
prefix will be forwarded.
Chapter 75 ARP Inspection
SECURITY > IPv6 Source Guard > IPv6 Static Binding > IPv6 Static Binding > Add/Edit
DESCRIPTION
Enter the IPv6 Address or IPv6 Prefix and prefix length in the binding.
Enter the source MAC address in the binding. If this binding does not check this field, select
Any.
Note: You cannot choose Any for all three of MAC Address, VLAN and Port. You
must fill in at least one.
Enter the source VLAN ID in the binding. If this binding does not check this field, select Any.
Specify the ports in the binding. If this binding has one port, select the first radio button and
enter the port number in the field to the right.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Clear to clear the fields to the factory defaults.
Click Cancel to not save the configuration you make and return to the last screen.
XGS2220 Series User's Guide
509