Port-Based Vlan Setup; Configure A Port-Based Vlan - ZyXEL Communications GS2220 Series User Manual

Table 58 Advanced Application > VLAN > VLAN Configuration > Vendor ID Based VLAN Setup
L ABEL
Cancel
Index
Name
MAC Address
Mask
VLAN
Priority
Weight
Delete
Cancel
9.12 Po rt- Ba se d VL AN Se tup
Port-based VLANs are VLANs where the packet forwarding decision is based on the destination MAC
address and its associated port.
Port-based VLANs require allowed outgoing ports to be defined for each port. Therefore, if you wish to
allow two subscriber ports to talk to each other, for example, between conference rooms in a hotel, you
must define the egress (an egress port is an outgoing port, that is, a port through which a data packet
leaves) for both ports.
Port-based VLANs are specific only to the Switch on which they were created.
Note: When you activate port-based VLAN, the Switch uses a default VLAN ID of 1. You
cannot change it.
Note: In screens (such as
The port-based VLAN setup screen is shown next. The
Ethernet ports.
9.12.1 C o nfig ure a Po rt- Ba se d VL AN
Select
Po rt Ba se d
Applic a tio n
DESC RIPT IO N
Click to clear the fields in the vendor ID based VLAN entry.
C a nc e l
This field displays the index number of the vendor ID based VLAN entry.
This field displays the name of the vendor ID based VLAN entry.
This field displays the source MAC address that is bind to the vendor ID based VLAN entry.
This field displays the mask for the source MAC address that is bind to the vendor ID based
VLAN entry.
This field displays the VLAN ID of the vendor ID based VLAN entry.
This field displays the priority level which is assigned to frames belonging to this vendor ID
based VLAN.
This field displays the weight of the vendor ID based VLAN entry.
Select an entry's check box to select a specific entry. Otherwise, select the check box in
the table heading row to select all entries.
Click to remove the selected entry from the summary table.
De le te
Click to clear the check boxes.
C a nc e l
IP Se tup
as the VLAN Type in the
> from the navigation panel to display the next screen.
VL AN
GS2220 Series User's Guide
Chapter 9 VLAN
and ) that require a VID, you must enter 1 as the VID.
Filte ring
management port forms a VLAN with all
C PU
>
Ba sic Se tting Switc h Se tup
151
screen and then click
Adva nc e d