ZyXEL Communications XGS2220 Series User Manual page 90

Table 29 Navigation Panel Links (Standard Mode) (continued)
LINK DESCRIPTION
PoE Setup For PoE models.
This link takes you to a screen where you can set priorities, PoE power-up settings and schedule so
that the Switch is able to reserve and allocate power to certain PDs.
Port Setup This link takes you to a screen where you can configure settings for individual Switch ports.
ZULD This link takes you to screens where you can enable ZULD on a port and configure related set-
tings.
SWITCHING
Layer 2 Proto- This link takes you to a screen where you can configure L2PT (Layer 2 Protocol Tunneling) settings
col Tunneling on the Switch.
Loop Guard This link takes you to a screen where you can configure protection against network loops that
occur on the edge of your network.
MAC Pinning This link takes you to a screen where you can set specific ports to have priority over other ports in
MAC address learning.
Mirroring Click the link to unfold the following sub-link menu.
Mirroring This link take you to a screen where you can copy traffic from one port or ports to another port in
order to examine the traffic from the first port without interference.
Multicast Click the link to unfold the following sub-link menu.
IPv4 This link takes you to screen where you can configure various IPv4 multicast features, IGMP snoop-
Multicast
ing, filtering and create multicast VLANs.
IPv6 This link takes you to screen where you can configure various IPv6 multicast features, MLD snoop-
Multicast
ing-proxy, filtering and create multicast VLANs.
MVR This link takes you to screens where you can create multicast VLANs and select the receiver ports
and a source port for each multicast VLAN.
Static This link takes you to a screen where you can configure static multicast MAC addresses for port(s).
Multicast
These static multicast MAC addresses do not age out.
Forwarding
By MAC
Static This link takes you to a screen where you can configure static multicast IP addresses for port(s).
Multicast
These static multicast IP addresses do not age out.
Forwarding
By IP
PPPoE Interme- This link takes you to screens where you can enable PPPoE (Point-to-Point Protocol over Ethernet)
diate Agent Intermediate Agent and configure per-port, per-port-per-VLAN settings.
QoS Click the link to unfold the following sub-link menu.
Diffserv This link takes you to screens where you can enable DiffServ, configure marking rules and set
DSCP-to-IEEE802.1p mappings.
Queuing This link takes you to a screen where you can set priorities for the queues of the Switch. This distrib-
Method
utes bandwidth across the different traffic queues.
Priority This link takes you to a screen where you can set priority tags for different traffic types and specify
Queue
the priority levels.
Bandwidth This link takes you to a screen where you can cap the maximum bandwidth allowed on a port.
Control
sFlow This link takes you to screens where you can configure sFlow settings on the Switch.
Spanning Tree Click the link to unfold the following sub-link menu.
Protocol
Spanning This link takes you to a screen where you can view the STP status in the different STP modes (RSTP,
Tree
MRSTP or MSTP) you can configure on the Switch.
Protocol
Status
Chapter 4 Web Configurator
XGS2220 Series User's Guide
90