Vlan; What You Can Do; What You Need To Know - ZyXEL Communications XGS2220 Series User Manual

Figure 444 SWITCHING > Multicast > IGMP Filtering Profile > Add Rule
The following table describes the labels in this screen.
Table 347 SWITCHING > Multicast > IGMP Filtering Profile > Add Rule
LABEL
Profile Name
Start Address
End Address
Apply
Clear
Cancel

79.32 VLAN

This section shows you how to configure 802.1Q tagged and port-based VLANs.

79.32.1 What You Can Do

• Use the VLAN Status screen
• Use the VLAN Detail screen
the static VLAN group.
• Use the Static VLAN screen
• Use the VLAN Port Setup screen
settings on a port.

79.32.2 What You Need to Know

Read this section to know more about VLAN and how to configure the screens.
Chapter 79 Networked AV Mode
DESCRIPTION
Select a profile from the drop-down list to add a additional rule for the existing profile.
Type the starting multicast IP address for a range of multicast IP addresses that you want to
belong to the IGMP filter profile.
Type the ending multicast IP address for a range of IP addresses that you want to belong to
the IGMP filter profile. If you want to add a single multicast IP address, enter it in both the Start
Address and End Address fields.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Clear to clear the fields to the factory defaults.
Click Cancel to not save the configuration you make and return to the last screen.
(Section 79.33 on page
(Section 79.33.1 on page
(Section 79.34 on page
(Section 79.35 on page
XGS2220 Series User's Guide
598
601) to view and search all static VLAN groups.
602) to view detailed port settings and status of
603) to configure a static VLAN for the Switch.
605) to configure the static VLAN (IEEE 802.1Q)