Configure Snmp User - ZyXEL Communications XGS2220 Series User Manual

The following table describes the labels in this screen.
Table 329 SYSTEM > SNMP
LABEL
General Setting
Use this section to specify the SNMP version and community (password) values.
Version
Get Community
Set Community
Trap Community
Trap Destination
Use this section to configure where to send SNMP traps from the Switch.
Index
Version
IP
Port
Username
Apply
Cancel

79.14 Configure SNMP User

Use this screen to create SNMP users for authentication with managers using SNMP v3 and associate
them to SNMP groups. An SNMP user is an SNMP manager. Click SYSTEM > SNMP > SNMP User to view the
screen as shown.
Chapter 79 Networked AV Mode
DESCRIPTION
Select the SNMP version for the Switch. The SNMP version on the Switch must match the
version on the SNMP manager. Choose SNMP version 2c (v2c), SNMP version 3 (v3) or both
(v3v2c).
SNMP version 2c is backwards compatible with SNMP version 1.
Enter the Get Community string, which is the password for the incoming Get- and GetNext-
requests from the management station.
The Get Community string is only used by SNMP managers using SNMP version 2c or lower.
Enter the Set Community string, which is the password for incoming Set- requests from the
management station.
The Set Community string is only used by SNMP managers using SNMP version 2c or lower.
Enter the Trap Community string, which is the password sent with each trap to the SNMP
manager.
The Trap Community string is only used by SNMP managers using SNMP version 2c or lower.
This is the index of a trap destination.
Specify the version of the SNMP trap messages.
Enter the IP addresses of up to four managers to send your SNMP traps to.
Enter the port number upon which the manager listens for SNMP traps.
Enter the user name to be sent to the SNMP manager along with the SNMP v3 trap.
This user name must match an existing account on the Switch (configured in the SYSTEM >
SNMP > SNMP User screen).
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
XGS2220 Series User's Guide
571