Anti-Arpscan Trust Host; Add/Edit Anti-Arpscan Trust Hosts - ZyXEL Communications XGS2220 Series User Manual

Table 267 SECURITY > Anti-Arpscan > Anti-Arpscan Setup (continued)
LABEL
Trusted State
Apply
Cancel

69.5 Anti-Arpscan Trust Host

Use this screen to create or remove trusted hosts identified by IP address and subnet mask. Anti-arpscan
is not performed on trusted hosts. To open this screen, click SECURITY > Anti-Arpscan > Anti-Arpscan Trust
Host.
Figure 347 SECURITY > Anti-Arpscan > Anti-Arpscan Trust Host
The following table describes the fields in the above screen.
Table 268 SECURITY > Anti-Arpscan > Anti-Arpscan Trust Host
LABEL
Index
Name
Host IP
Mask
Add/Edit
Delete

69.5.1 Add/Edit Anti-Arpscan Trust Hosts

Use this screen to add/edit trusted hosts identified by IP address and subnet mask. Click Add/Edit, or
select an entry and click Add/Edit in the SECURITY > Anti-Arpscan > Anti-Arpscan Trust Host screen to
view this screen.
Chapter 69 Anti-Arpscan
DESCRIPTION
Select Untrusted or Trusted for the associated port. Anti-arpscan is not performed on
trusted hosts.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click this to reset the values in this screen to their last-saved values.
DESCRIPTION
This field displays a sequential number for each trusted host.
This field displays the name of the trusted host.
This field displays the IP address of the trusted host.
This field displays the subnet mask of the trusted host.
Select an entry's check box to select a specific entry. Otherwise, select the check box in
the table heading row to select all entries.
Click Add/Edit to add a new entry or edit a selected one.
Click Delete to remove the selected entries.
XGS2220 Series User's Guide
472