Add/Edit Ipv6 Neighbor; Dhcpv6 Client Setup - ZyXEL Communications XGS2220 Series User Manual

30/54-port gbe/sfp smart managed layer-3 switch
Table of Contents

Advertisement

Table 75 SYSTEM > IPv6 > IPv6 Neighbor Setup (continued)
LABEL
Add/Edit
Delete

24.10.1 Add/Edit IPv6 Neighbor

Use this screen to create a static IPv6 neighbor entry. Click Add/Edit, or select an entry and click Add/
Edit in the SYSTEM > IPv6 > IPv6 Neighbor Setup screen to display this screen.
Figure 134 SYSTEM > IPv6 > IPv6 Neighbor Setup > Add/Edit
The following table describes the labels in this screen.
Table 76 SYSTEM > IPv6 > IPv6 Neighbor Setup > Add/Edit
LABEL
Interface
Interface ID
Neighbor
Address
MAC
Apply
Clear
Cancel

24.11 DHCPv6 Client Setup

Use this screen to configure the Switch's DHCP settings when it is acting as a DHCPv6 client. Click SYSTEM
> IPv6 > DHCPv6 Client Setup to display the screen as shown next.
Chapter 24 IPv6
DESCRIPTION
Click Add/Edit to add a new entry or edit a selected one.
Click Delete to remove the selected entries.
DESCRIPTION
Select the type of IPv6 interface for which you want to configure. The Switch supports the VLAN
interface type for IPv6 at the time of writing.
Specify a unique identification number (from 1 to 4094) for the interface.
A static IPv6 neighbor entry displays in the MONITOR > IPv6 Neighbor Table screen only when the
interface ID is also created in the SYSTEM > Interface Setup screen.
To have IPv6 function properly, you should configure a static VLAN with the same ID number in the
SWITCHING > VLAN screens.
Specify the IPv6 address of the neighboring device which can be reached through the interface.
Specify the MAC address of the neighboring device which can be reached through the
interface.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Click Clear to clear the fields to the factory defaults.
Click Cancel to not save the configuration you make and return to the last screen.
XGS2220 Series User's Guide
184

Advertisement

Table of Contents
loading

Table of Contents