Static Arp - ZyXEL Communications XGS2220 Series User Manual

30/54-port gbe/sfp smart managed layer-3 switch

Table of Contents

Figure 301 NETWORKING > ARP Setup > ARP Learning

The following table describes the labels in this screen.

Table 226 NETWORKING > ARP Setup > ARP Learning

ARP Learning

61.3 Static ARP

Use this screen to view and configure static ARP entries that will display in the MONITOR > ARP Table

screen and will not age out. Click NETWORKING > ARP Setup > Static ARP to display the screen as shown.

This field displays the port number.

Settings in this row apply to all ports.

Use this row only if you want to make some settings the same for all ports. Use this row first to set

the common settings and then make adjustments on a port-by-port basis.

Changes in this row are copied to all the ports as soon as you make them.

Select the ARP learning mode the Switch uses on the port.

Select ARP-Reply to have the Switch update the ARP table only with the ARP replies to the ARP

requests sent by the Switch.

Select Gratuitous-ARP to have the Switch update its ARP table with either an ARP reply or a

gratuitous ARP request.

Select ARP-Request to have the Switch update the ARP table with both ARP replies, gratuitous

ARP requests and ARP requests.

Click Apply to save your changes to the Switch's run-time memory. The Switch loses these

changes if it is turned off or loses power, so use the Save link on the top navigation panel to save

your changes to the non-volatile memory when you are done configuring.

Click Cancel to begin configuring this screen afresh.

XGS2220 Series User's Guide