ZyXEL Communications XGS2220 Series User Manual page 169

Figure 117 SYSTEM > IP Setup > Network Proxy Configuration
The following table describes the labels in this screen.
Table 59 SYSTEM > IP Setup > Network Proxy Configuration
LABEL DESCRIPTION
Active Enable the switch button to enable communication between the Switch and NCC through a
proxy server.
Server Enter the IP address (dotted decimal notation) or host name of the proxy server. When entering
the host name, up to 128 alphanumeric characters are allowed for the Server except [ ? ], [ | ],
[ ' ], or [ " ].
Port Enter the port number of the proxy server (1 – 65535).
Authentication Enable the switch button to enable proxy server authentication using a Username and
Password.
Username Enter a login user name from the proxy server administrator. Up to 32 alphanumeric characters
are allowed for the Username except [ ? ], [ | ], [ ' ], or [ " ].
Password Enter a login password from the proxy server administrator. Up to 32 alphanumeric characters
are allowed for the Password except [ ? ], [ | ], [ ' ], or [ " ].
Apply Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to reset the fields to your previous configuration.
Chapter 23 IP Setup
XGS2220 Series User's Guide
169