Warranty Considerations - Konica Minolta Magicolor 3300 User Manual

Warranty Considerations

Various factors can affect a printer's warranty, such as electrostatic damage,
unsupported consumables, and other actions listed on the following page.
Read your printer warranty carefully. For information about your warranty, go
to printer.konicaminolta.net/support, then click on the Answer Base.
If KONICA MINOLTA printer failure or damage is found to be directly attribut-
able to the use of non-KONICA MINOLTA approved consumables, print
media, and/or accessories, KONICA MINOLTA will not repair the printer free
of charge. In this case, standard time and material charges will be applied to
service your printer for that particular failure or damage.
These Actions Will Result in Voiding Your Warranty
Print Media
Electrostatic
Discharge
Instructions
Modifications
Consumables
Imaging Unit or
Transfer Roller
Accessories
Warranty Considerations
Use of nonsupported transparency (OHP) media,
such as coated color transparencies.
Use of other nonsupported print media, such as ink
jet paper.
See chapter 2, "Using Media," in the User's Guide for
information about media. Check printer.konicaminolta.net/
support (click on Answer Base) for currently approved
media. To order approved transparency media, go to
www.q-shop.com.
Failure to protect the printer controller board and any
associated daughterboard or module from electrostatic
discharge or damage while performing any task involving
the controller board.
Failure to follow instructions in the printer documentation.
Any modifications or changes to this product not expressly
approved in writing by the manufacturer responsible for
compliance to Federal Regulations could void your
authority to operate this product within the Laws and
Regulations of the Federal Communications Commission.
Use of consumables not manufactured or supported by
KONICA MINOLTA. Any damage to the printer or quality
problems caused by a refilled toner cartridge use.
Any damage resulting from mishandling the imaging unit
(including its four OPCs) or the transfer roller.
Use of accessories not manufactured/supported by
KONICA MINOLTA.
181