Konica Minolta Magicolor 3300 User Manual page 112

Symptom
Printing takes
too much time.
You are experi-
encing prob-
lems duplexing.
The printing is
on the wrong
side of the
media.
Characters
print
incorrectly.
104
Cause
The printer is set to a
slower printing
(Thick Stock or
Transparency media
types).
The printer is set to
energy-saving mode.
The printer memory
is insufficient.
The job is very
complex.
Media or settings are
not correct.
The printer is set to
autoduplexing and
you are trying to
duplex manually.
The media is not
installed correctly.
The fonts are set
incorrectly on your
printer driver.
Solution
It takes more time to print with special
media types, such as Transparency or
Thick 2. When using regular paper, make
sure that the media type is set to Plain
Paper in the driver.
It takes a little time for printing to start in
energy-saving mode. If you do not want to
use this mode, disable it (Administration/
Engine/Energy Saver Mgt menu).
Add more memory.
Wait. No action needed.
Make sure that you are using the correct
media. Do not duplex envelopes, glossy
stock heavier than 28 lb bond (105 g/m²),
labels, postcards, thick stock heavier than
28 lb bond (105 g/m²), or transparencies.
Make sure that your document has more
than one page.
In the printer driver (Properties/Layout/
Duplex Options), choose Short Edge
(flipped as on a clipboard) or Long Edge
(flipped as in a loose-leaf notebook). Make
sure that you are using correct media.
If you are manually duplexing, in the printer
driver (Properties/Layout) choose Simplex.
From the upper or optional trays, load the
media printing-side up, from the multi-
purpose tray, load the media printing-side
down.
Check your driver (Properties/Fonts tab) to
make sure you are using the correct fonts
(such as TrueType fonts).
Solving Problems