Konica Minolta Magicolor 3300 User Manual page 129

This message...
MEDIA JAM
DUPLEX
MEDIA JAM FEED
MEDIA JAM FUSER
MEDIA JAM
REGISTRATION
MEDIA TYPE
MISMATCH
MISMATCH JAM
OUTPUT BIN FULL
PRINTING STATUS
PUT <SIZE>
PAPER IN <ANY>
BIN
Status, Error, and Service Messages
means...
Media has jammed in
the duplexer.
Media has jammed
while being pulled from
the specified tray.
Media has jammed
leaving the fuser area.
Media has jammed in
front of the imaging unit.
The media detected in
the tray doesn't match
the media size or type
setting.
Media has jammed near
the transparency sen-
sor.
The media has
exceeded the limit (such
as over 250 sheets of 20
2
lb [75 g/m ] bond) in the
output bin.
A status page is
printing.
The Operator Control/
Chain Inputbins is set to
Off and the displayed
tray is empty. Refill it
with the specified size
media. <SIZE> is the
media size detected by
the engine, and <ANY>
is the empty tray.
do this...
Locate and remove the
jam. Open and close the
front door to reset the
printer.
Change the media in the
tray or change the media
size or type setting
Locate and remove the
jam. Open and close the
front door to reset the
printer.
Remove the media from
the output bin.
Wait until after the status
page prints and the mes-
sage clears.
Refill the tray with the
specified size media.
121