Konica Minolta Magicolor 3300 User Manual page 143

5
If you need to remove a DIMM before installing one, remove it as follows;
otherwise, skip to step 6.
a
Using both thumbs,
pull the latches (one
on each side of the
DIMM connector)
outward.
b
Lift the DIMM straight
out of the DIMM con-
nector.
6
Insert the new DIMM
straight down into the
DIMM connector until
the latches snap into the
locked position.
Observe the keyed side
of the DIMM to align it
with the connector.
When seated, the DIMM
stands upright, firmly in
place. If you cannot
snap the DIMM into
place, do not force it.
Reposition it, making sure that the bottom of the DIMM is seated com-
pletely in the connector.
7
Reinstall the controller
board into the printer.
Gently slide the
controller board into
the printer's tracks
until it is fully seated,
and then tighten the
two screws.
8
Reconnect all
interface cables.
Dual In-Line Memory Modules (DIMMs)
135