Software Utilities Cd-Rom; Automatic System Software Update; Drivers And Utilities - Konica Minolta Magicolor 3300 User Manual

Software Utilities CD-ROM

If you followed all the steps in the Installation Guide that came with your
printer, then the printer is properly set up, connected to your computer,
plugged in, turned on, and ready to receive the system software, drivers, and
utilities on the Software Utilities CD-ROM.
Put the CD-ROM in your computer's CD-ROM drive, and the AutoInstaller
begins the installation process.

Automatic System Software Update

The AutoInstaller provides the option to upgrade the printer firmware when
installing a printer driver. This option may also be accessed from the
Additional Software selection on the AutoInstaller's Main Menu.
If you attempt to download a previous version of system software, an error
page prints stating "Low Release Level." This prevents an older version of
system software from being downloaded over a newer version.
The system software update aborts without operator intervention if the
system software on the CD-ROM is the same as, or older than, the one
currently installed on the printer controller.
If you are installing new system software, you may have to wait up to
10 minutes for the update. Do not interrupt the process.

Drivers and Utilities

The printer driver and additional software on the Software Utilities CD-ROM
can be installed on PC, Macintosh, and other computers using any of the
following:
Windows Me
Windows 98
Windows 95 (B minimum)
Windows XP
Windows 2000
Windows NT4
2
Macintosh OS 9 (version 9.2.1 or
higher) or X (version 10.1.4 or
higher)
UNIX/Linux
NetWare (Versions 5 and 6)
NDPS
Software Utilities CD-ROM