System Setup; Overview - Graco PCF Instructions - Parts Manual

System Setup

Overview

The PCF system compensates for temperature, flow, or
pressure fluctuations. However, if there is a hardware
change on the supply system or the dispense material is
changed, the PCF system must be setup again.
After material is loaded into the supply system, set up
the PCF system using the Setup screens. F
the major system setup steps. The following subsec-
tions provide instructions to complete each setup step.
Once these steps are complete the module is ready for
operation.
NOTE: See the Advanced Display Module (ADM)
section, page 14, and Appendix A - Advanced Dis-
play Module (ADM), page 85, for detailed operating
instructions for the display keypad and each screen.
313377L
. 16 shows
IG
F . 16
IG
System Setup
Configure Control Settings (page 26)
Configure Mode Settings (page 27)
Configure Delay Settings (page 28)
Configure Flow Meter
Settings (page 28)
Configure Pressure Loop
Settings (page 29)
Adjust Pressure Sensors (page 29)
Configure Errors (page 30)
Setup Maintenance
Schedule/Parameters (page 31)
Configure Gateway
Settings (page 31)
Setup Styles (page 31)
Configure Advanced
Settings (page 31)
End System Setup
System Setup
25