Omron SmartSlice GRT1-OD4G-1 Operation Manual page 76

Functions of Digital I/O Units
Setting with a
Programming Device
1,2,3...
56
In Figure 2, the actual ON time is 0.5 s × 3 = 1.5 s. The reading will be taken
twice during this ON time, so the total ON time will be measured as 2 s.
Reading taken approximately every second.
ON
OFF
0.5 s
Figure 2
■ Measurement for ON time of 1.5 s:
In Figure 3, the actual ON time is 1.5 s × 2 = 3 s. The measurement will be tak-
en four times during this ON time, so the total ON time will be measured as 4 s.
Reading taken approximately every second.
ON
OFF
1.5 s
Figure 3
This example shows how to use the DeviceNet Configurator (version 2.43 or
higher) to set the Total ON Time Monitor function.
1. Open the Network Configuration Window and double-click the desired
Slice I/O Terminal's icon or right-click the icon and select Parameters -
Edit to display the Edit Device Parameters Window. Select the desired
Slice I/O Unit from the list on the I/O Module Tab Page and click the Edit
Button to display the Edit Unit Parameters Window.
2. Select the IN Tab.
Section 4-4