Omron SmartSlice GRT1-OD4G-1 Operation Manual page 159

Analog Output Units
Setting Using the
DeviceNet Configurator
1,2,3...
Pin No.
3 Reserved
4 Set the range setting method.
Output range
0 to 5 V (Factory set-
ting)
1 to 5 V
0 to 10 V
–10 to 10 V
GRT1-DA2C
■
Each pin is set according to the following table.
Pin No.
1 Set output range for Outputs 0
and 1.
2 Reserved
3
4 Range setting method
Output range
4 to 20 mA
0 to 20 mA
Use the following procedure to set the output range for each output using the
Configurator.
1. In the Network Configuration Window for the Slice I/O Terminal, double-
click the icon of the Slice I/O Terminal that is to be set. Alternatively, right-
click the icon and select Parameters - Edit. The Edit Device Parameters
Window will be displayed.
2. Click the I/O Module Tab.
3. Click the Edit Button on the I/O Module Tab Page. The Edit Unit Parame-
ters Window will be displayed.
4. Select the tab page for the output where the range is to be changed.
Setting
Pin 1
OFF OFF
ON OFF
OFF ON
ON ON
Setting
Pin 1
OFF Fixed at OFF.
ON
Section 5-5
Specifications
Fixed at OFF.
OFF: Set using Setting Tool.
ON: Set using DIP switch.
Default setting: OFF
Pin 2 Pin 3
Fixed at OFF.
Specifications
Default setting: All pins OFF
Fixed at OFF.
OFF: Set using Setting Tool.
ON: Set using DIP switch.
Default setting: OFF
Pin 2 Pin 3
139