Omron SmartSlice GRT1-OD4G-1 Operation Manual page 55

Installation
Removing an Entire Unit
Including the Base Block
1,2,3...
Removing Just a Unit's
Main Block
Removing Only the
Terminal Block
1. Remove the main block of the Unit on the right side of the Slice I/O Unit
actually being replaced.
2. Release the Mounting Hook locks of the Unit being replaced. (The hooks
attach the Unit to the top and bottom of the DIN Track.)
3. Pull the Unit straight away from the DIN Track.
B
C
A
B
Press the latches on the top and bottom of the main block and pull the block
forward.
Press the latches on the top and bottom of
the main block and pull the block forward.
Release the hooks on the top and bottom of the terminal block and pull out the
terminal block.
Unit being replaced
Release the hooks on the top
and bottom of the terminal block.
Section 3-1
35