(Optional) Connecting The Monitor, Keyboard, Mouse, And Power; Connecting To The Printer - EFI E-85 Installation And Service Manual

(Optional) Connecting the monitor, keyboard, mouse, and power

Before using the E-85, connect the monitor, keyboard, mouse, and power to the E-85 if applicable.
To connect the monitor, keyboard, mouse, power cable
1 Make sure that the E-85 is installed in the furniture.
For more information, see the assembly instructions that accompany the furniture.
2 Connect the monitor cable to the HDMI port from the graphic board on the connector panel.
3 Connect the monitor power cable to an outlet of the power strip inside the furniture.
Be sure to use the appropriate power cable for your regional outlet type.
4 Place the keyboard and mouse on the furniture table top.
5 Connect the wireless adapter for the keyboard and mouse to one of the USB port that is attached to the furniture stand.
6 Power on the mouse by using the power switch on the bottom side of the mouse.
7 Connect the recessed end of the E-85 power cable to the power connector on the power strip inside the furniture.
Be sure to use the appropriate power cable for your regional outlet type.

Connecting to the printer

Use the following procedure to connect the E-85 to the printer.
To connect to the printer
1 Shut down the E-85 (see
2 Locate the two printer interface cables provided with the E-85.
3 Power off the printer using the main power switch located behind the front cover.
4 If needed, shut down the E-85 (see
5 Locate the printer interface cable (crossover Ethernet cable) that shipped with the E-85.
For information on the USB connection used for the power synchronization, see
page 38).
page 40).
Installation and Service Guide: Color Controller E-85
"Power synchronization"
20
Installing hardware
on page 25.