EFI E-85 Installation And Service Manual page 12

Work on a grounded antistatic mat.
•
Wear an antistatic wristband, attached to the same location as the antistatic mat.
•
Before you remove an electronic component from the shipping box, touch a metal area of the printer to discharge static
•
from your body.
• After you remove an electronic component from the shipping box, place it face up on a grounded antistatic surface.
Leave electronic components in antistatic bags until you are ready to use them.
•
Do not walk on carpet or vinyl while carrying an electronic component, unless it is in an antistatic bag.
•
If you remove an electronic component from the printer, immediately place it in an antistatic bag.
•
The power cable
Observe the following guidelines:
Only use the power cable that shipped with the E-85 or an appropriate replacement power cable. For replacement parts,
•
see your authorized service support center.
Before you open the E-85, unplug the E-85.
•
• Keep the power cable away from foot traffic.
• Do not place objects on the power cable.
Do not plug the E-85 into a 2-hole, ungrounded outlet by means of a 3-prong adapter.
•
Do not plug the E-85 into a circuit connected to heating or refrigeration equipment (including a water dispenser).
•
Do not plug the E-85 into a switchable outlet.
•
• Do not pull the cable to unplug the E-85. Instead, pull the plug.
• Do not tamper with or disable the power cable grounding plug.
Do not use an extension cord.
•
Do not bring liquids near the E-85
If liquid spills on the E-85, immediately unplug the E-85.
Do not open the power supply
For more information about the power supply, see
Do not open the hard disk drive
For more information about the hard disk drive, see
Lift the E-85 carefully
The E-85 weighs approximately 22kg. At least two persons are required to move the device.
Installation and Service Guide: Color Controller E-85
"Power supply" on page 74.
"Hard disk drives" on page 76.
12
Introduction