Dvd Drive - EFI E-85 Installation And Service Manual

To install a replacement hard disk drive inside the security enclosure
Important: Be sure to perform all the steps of this procedure exactly as described. If you fail to perform all the steps
of this procedure, system problems may result.
1 Remove the old hard disk drive from the enclosure, and install the replacement hard disk drive inside the enclosure.
For detailed instructions, see the documentation that accompanies the HDD Security Option.
2 Power off the enclosure using the enclosure's main power button.
3 Wait one minute.
4 Power on the enclosure using the enclosure's main power button.
5 Install system software (see
If a startup error appears on the monitor when you power on the E-85, check the connections.
6 Verify E-85 functionality (see

DVD drive

The DVD drive is installed in the front of the chassis. The drive is used to install system software and archive data on
writable media.
To remove the DVD drive
1 Shut down the E-85, remove all cables from the back, and then open the system (see
To access the DVD drive, you must remove the left, right, and front panels from the chassis.
2 Remove the data/power cables from the dual connector on the back of the DVD drive.
If you are removing the cable assembly to replace it with a new cable assembly, detach the other ends of the cables
from the motherboard and the power supply.
page 100).
page 83).
Installation and Service Guide: Color Controller E-85
page
Replacing parts
48).
81