Setting Customer Expectations; Unpacking The E-85 - EFI E-85 Installation And Service Manual

4 Side panel
5 Fiery Quick Touch display panel
6 Front panel
Is a dedicated, grounded electrical outlet for the E-85 available near the printer?
•
Do not run the E-85 and the printer on the same circuit. If the customer has provided one, use a surge suppressor for the
E-85.
• Will the network be available at the time of installation? (See the site administrator.)

Setting customer expectations

When the site is ready, installation of the E-85 takes about 1 hour. Inform the customer of the following:
• Some nodes on the network may be unavailable during service.
• The site administrator must be available during the installation for network connectivity.
Equipment downtime and impact on the network can be minimized if the site administrator installs a network connector
for the E-85 and confirms network functionality with the connector in place before the date scheduled for the E-85
installation.
The site administrator must have a networked computer available during the installation. The appropriate software
•
must be installed in advance. Documentation for the networked computer and the network operating software should be
available.
• The site administrator is responsible for installing the user software shipped with the E-85 onto networked Windows
and Mac OS computers that will print to the E-85 (user documentation is also included).

Unpacking the E-85

Warning: Before you unpack the E-85, it is strongly recommended that you review all
avoid injury or damage to the E-85.
The E-85 ships with all of the cables and documentation required for setup.
The E-85 weighs approximately 22kg. At least two persons are required to move the device.
To unpack the E-85
It is strongly recommended that you save all packing materials in case you need them later (for example, if you discover
something is damaged and need to return it). Do not immediately discard packing materials.
1 Remove the top cover from the main shipping container.
2 Remove the box that contains the E-85.
3 Remove the accessory kit from the E-85 box and check it for damage.
Installation and Service Guide: Color Controller E-85
Installing hardware
"Precautions" on page 10 to
16