Installing Hardware; About The Installation Process - EFI E-85 Installation And Service Manual

Installing hardware

About the installation process

It is strongly recommended that you review this chapter before you install the E-85. Also keep in mind that installation
problems are easier to avoid and diagnose if you proceed from the component level to the system level, verifying
functionality at each step.
Since the E-85 is connected to the customer's network, be sure to coordinate your installation schedule with the
administrator at the customer site. For information about network setup, refer the site administrator to
Configuration Guide, which is part of the user documentation set.
If necessary, you can change the default language of the E-85 set at the factory (see
page 15).
Note: You can change the default language that is preinstalled at the factory using the Configure tool available through
Command WorkStation and WebTools. Start Configure, choose Fiery Server > Regional Settings. From the Server
Language list, select your language and then click Save. When an Alert dialog box appears, click Continue. It takes up to
15 minutes to change languages.
You can also change the default language using the Fiery Quick Touch menu. Select Quick Launch > Settings, and log in to
the server as admin. From the language drop-down list, select the your language, save the changes, and then reboot the
server. It takes up to 15 minutes to complete the language changes.
To install the E-85
1 Check installation requirements and verify site conditions.
If possible, obtain verification that the network is operational (see
2 Unpack the E-85 (see
3 If applicable, connect the monitor, keyboard, mouse, and furniture to the E-85.
For more information on setting up the furniture, see the documentation that comes with the furniture kit.
4 Connect the following cables (see
• Printer interface (Data Transfer Unit) cables
• Printer interface cables
• Network cable (upper RJ-45)
5 (Optional) If the E-85 requires a static IP address (for example, in a non-DHCP network environment), work with the
site administrator to configure one.
6 Locate the EFI/Fiery decal in the shipping container and affix it to the printer as shown.
7 Complete the installation (see
page 16).
page 17).
page 26).
"To change the E-85 language"
page 15).
on