EFI E-85 Installation And Service Manual page 40

7 If Command WorkStation starts automatically, connect to the E-85 with Administrator privileges.
If Command WorkStation was connected to the E-85 during the previous session, the connection may be reestablished
automatically.
If the E-85 is currently disconnected, select the E-85 from the Servers List and click Connect. Choose Administrator
from the User menu, type Fiery.1 in the Password field, and then click Login.
Note: Fiery.1 is the default password required to connect to the E-85 with Administrator privileges. The password can be
changed in E-85 Setup. For more information, see Configuration and Setup which is part of the user documentation set.
To shut down, restart, or reboot the E-85 from the Fiery QuickTouch
Note: Notify the site administrator before you remove the E-85 from the network.
1 Make sure that the E-85 is not receiving, processing, or printing any files.
If the system has just finished processing, wait at least 5 seconds after the system reaches Idle before beginning the
shutdown procedure.
2 At the Idle is displayed, press the bots at the upper right corner of the screen.
3 Make a selection:
• To shut down the E-85, select Shutdown system.
• To reboot the entire system including the operating system, select Reboot system.
To restart the Fiery system software only, select Restart server.
•
4 At the confirmation screen, select OK.
Allow the system to shut down and power off or restart.
If you selected Restart server, you may need to wait one minute or more for the server software to restart.
To shut down, restart, or reboot from the printer touch panel
Note: Notify the network administrator before you remove the E-85 from the network.
1 Make sure that the E-85 is not receiving, processing, or printing any jobs.
If Printing appears on the Fiery QuickTouch, the E-85 is processing. You must wait until the system finishes and
reaches Idle before restarting or shutting down.
If the system has just finished processing, wait at least five seconds after the system reaches Idle before beginning the
shutdown procedure.
2 Press Home button on the printer operational panel.
Installation and Service Guide: Color Controller E-85 40
Using the E-85